The technology of the wallpaper printer is constantly being updated and replaced. Today, we will introduce the reason and replacement of the contact belt of the wallpaper printer.

When the wallpaper printer reports an error, shut it down in time, otherwise it may burn out the contact belt, print head, car board, data cable, and main board. Especially when the error message reported by the wallpaper printer is current overload or temperature is overheated, the printing machine reports such an error, which means that there is a short circuit in the print head of the wallpaper printer. If it cannot be shut down in time, it will affect the contact belt, car board, data line, and main board.

What should I do when the contact belt burns? Let stormjet wallpaper printer group teach you how to replace the electric contact belt. The method is for your reference only, and the specific situation can be analyzed in detail.

First unplug the power cord and data line on the wallpaper printer, remove the printhead, remove the car cover, unplug the data line, grating sensor, paper sensor on the car board, remove the car board, remove the fixing of the contact belt, then gently move the contact belt down, remove the contact belt; then put the new contact belt in from the front of the car frame, and the round hole at the lower end of the contact belt is stuck in the lower end of the car frame. At the place where the print heads are placed, there are a few protruding small piles underneath. On the contact strip, there are two small holes in the position of each print head. There are eight small holes in total, which is to align with the eight protrusions. It must be placed well,the contact belt can be stable, so that there is no bad contact. Finally, put the machine back and check whether it is operating normally.