In the process of using the stormjet printer, there are often problems such as pauses on both sides or slow speed and sudden shutdown during printing. Below, stormjet printer will teach you how to solve this problem:

First, let's analyze the causes of this failure of the stormjet piezoelectric printing machine: 　　
1. The connectors at both ends of the cable connected to the printer are loose, the contact is bad or has fallen off; 　　
2. The length of the printing line used is too long (such as a USB line), the USB power supply is insufficient; 　　
3.The stormjet piezoelectric printing machine cannot recognize the ECP printing port of the computer.

Secondly, through the above reason analysis, let's solve it from the point of failure 　　
1. First check whether the length of the connecting cable of the stormjet printer is too long, generally the best length within 3 meters; or the poor quality of the cable will affect the accuracy of data transmission, so we recommend using IEEE less than 3 meters in length, 1284 double-shielded ECP Cable; 　　
2. The problem that the computer does not recognize the print port, the solution: restart the computer, press the DEL key (some computers press F2) during the hardware self-test of the computer to enter the CMOS settings of the main board, enter the INTEGRATEDPERIPHERALS option, find ParallelPortMode and set it to ECP, finally press F10 to save and exit the BIOS settings, restart the computer to enter the system, see if it is connected, and recognize the print port.