What should we do when faced up with the phenomenon that the carriage stops, the printing speed is slow or carriage stops suddenly while the carriage goes at both sides of the guide rail? Below we would like to further explain it for you, how to solve these problems when we meet with this kind of problem.
The main reasons for this kind of problems are:
A. The printing wire connector is loose
B. The printing wire is too long
C. The servo motor is damaged.
The solutions:
A. Check if there's any loose for printing wire and then change the printing line to avoidn the problem in the printing wire.
B. Too long or poor quality printing wire will affect the validity of the transfer, so we recommend the length of printing wire should be less than three meters.
C. Replace the servo motor.